SSOT v3.7 · Contractor Detail Drawing · Acoustic Design Basis

Stagebox & Signal Conduit Details

Signal infrastructure keeps the essential SB-01 VO Live link in Wall 6 while Video Studio now operates independently with local floor-box / recorder workflow only. Stagebox, conduit sleeve, tray routing, and the Control Room rack landing are documented here for electrical and AV coordination.

Face Plate
300 × 200 mm
Wall Sleeve
50 mm EMT
Tray Width
150 mm local services
Rack Landing
Apollo x4 + patch bay

Drawing 1 — SB-01 Face Plate

Center at 90 cm AFF

Front elevation of the Control Room stagebox faceplate with balanced audio and utility terminations grouped by function.

300 mm 200 mm 12 x XLR female 4 x XLR male 2 x TRS 1 x RJ45 90 cm AFF center

Drawing 2 — Conduit Through W6

Both faces sealed [AC]

Signal conduit crossing W6 uses a 50 mm EMT sleeve with a 10 mm annular gap and Tremco Fyre-Sil on both wall faces.

10 mm [AC] Both faces sealed — annular gap filled 50 mm EMT conduit through W6 wall assembly Tremco Fyre-Sil each face, no rigid mortar pack

Drawing 3 — Cable Tray in Buffer Spine

SB-01 southbound + local Studio services

A 150 mm wide tray rises through the buffer spine and separates the southbound SB-01 bundle from local Studio floor-box services only. No northbound Video Studio stagebox run exists in SSOT v3.7.

SB-01 cables south to Control rack Local Studio floor-box / recorder services only 150 mm cable tray full spine height

Drawing 4 — Control Room Rack Layout

Apollo x4 landing

The Control Room rack receives the SB-01 bundle at the bottom and lands the patching hardware directly above the interface position for short analog tie lines.

U12 — spare vent panel U11 — 1U patch bay U10–U9 — Apollo x4 on vented shelf U8 — power conditioner U7 — network switch U6 — spare U5–U3 — SB-01 cable service loop entry SB-01 cables arrive at rack bottom